He’s Not Biking, But He’s Using a BOB Trailer

The weather was perfect in South Florida back in March of 2005, so I headed out for the Lake Okeechobee Scenic Trail (LOST). (Temps were 63 to 74, but the weatherman lied about 5 mph winds, decreasing to calm. They were really 5 to 7, increasing to 7 to 10, by my wind gauge.)
Steve Fugate repacks his modified BOB trailer
About eight miles into my ride, I saw something breaking the horizon. I figured it was another biker or hiker, but we didn't seem to be closing as quickly as I would have thought.

When I got closer, I didn't see a bike, but there was some kind of contraption on the ground and colorful stuff scattered all over the trail. Looked kind of like a rag bag had vomited its contents. The guy was busy stuffing the bits and pieces into waterproof bags.

Turns out I'd run into Steve Fugate from Vero Beach, who was on the last legs of his marathon hike around the country. Continue reading “He’s Not Biking, But He’s Using a BOB Trailer”

Swagman rack drags on Honda Odyssey

When I tried to use my Swagman hitch-mounted rack on my 2000 Honda Odyssey minivan, I had to be careful to keep the bikes from dragging.

I debated having an extension welded to the upright, but decided to take a less destructive approach. I went to a local trailer store where I bought a short hitch with a drop / rise. Normally it’s installed to lower the mounting ball on vehicles with high bumpers.

I needed it to work in the opposite direction: to raise the mounting point on a low hitch. I mounted the hitch upside down, so it was higher than the original hitch. This picture shows a comparison between the original hitch and the new one. The extra height made a big difference.

Swagman hitch for Honda Odyssey minivan

I eventually replaced the traditional trailer ball with a bolt that was easier to tighten.

Adjusting a Brooks Champion Flyer Saddle

When I bought my Brooks Champion Flyer saddle, I read everything I could about how to break it in properly. Some cyclists swear by leather Brooks saddles, others say that nothing they could do would make it feel like anything but an “ass hatchet”

Some sites recommended break-in procedures that used to be prohibited by the Geneva Convention: water torture by soaking the saddle in water to soften the leather; dipping in molten wax; motor oil baths and the like.

I opted for a more conservative approach. I put a heavy coating of Proofide, the BrooBrooks Champion Flyer with Proofide treatmentks recommended treatment, on the underside of the saddle to protect it from water thrown up from underneath. Then, for several days, I would lovingly caress the top of the saddle with Proofide, figuring that more has to be better, right?

The upside was that I had a very soft, comfortable saddle that quickly molded itself to my backside. Unfortunately, soft can sometimes mean sagging. The leather stretched, causing the skirt or sides of the saddle to splay out when I sat on it, chafing my thighs and wearing out my shorts.

That’s not a good thing.
Continue reading “Adjusting a Brooks Champion Flyer Saddle”

Phil the Knife Sharpener is a Trailer Guy

If you want to start an argument on a bicycle touring list, ask the question, “Which is better panniers or a trailer?” The world is divided into two groups, trailer cyclists and pannier cyclists and each group is passionate about his or her choice.

Back in February 2002, on a ride from West Palm Beach to Hobe Sound, FL, and back, I ran into Phil the Knife Sharpener near the Riviera Beach FP&L power plant.

Phil, it goes without saying, is a trailer guy. Phil is a Big Trailer Guy in more ways than one.

Closeup of Phil\'s trailer

I asked him where he was headed.

“Daytona Beach,” he said.

Where did you start?

“Key West.”

Where you going after Key West?

“South Dakota.”

At that point, I said, “We have to talk. How MUCH does that trailer
weigh?”

“About 300 pounds. I’m another 275 pounds,” he added.

How hard is that thing to pedal?

“I’m in a mid-range gear right now, give it a shot,” he offered.

I climbed on the beast, stood up on the pedals and went…..nowhere. Zip, nada, zilch.

“That’s what happens most of the time someone tries that,” he laughed, reaching down and lifting the trailer straight off the bolt that held it to his frame.
The bolt that holds the bike to the trailer.
“Does that thing ever pop off when you’re riding,” I asked?

“Yeah, a few times. Once I was going down a steep hill doing about 40 miles per hour riding the brakes when I hit a speed bump. The trailer popped off. When the load came off, then the brakes grabbed hold and the trailer tried to pass me. This trooper saw things start to get interesting and asked if I was hurt. ‘Yep,’ I said. He wanted to know if he should call an ambulance. ‘Yep,’ I said. He wanted to know if I wanted to get down off my bicycle. ‘Nope,’ I said. ‘I got a broken leg.'”

Phil said he had ridden about 250,000 miles in the last 18 years, most of them on the beater bike and trailer he was riding here.

When we approached the Port of Palm Beach flyover, a fairly good grade for these parts, I said, “I don’t get much hill climbing experience down here, so I hope you don’t show me up too badly.”

About 15 feet up the incline, Phil said, “OK, I’ve run it out as far as it’ll go. I’ll walk it from here.” And that’s what he did.

Understanding why he didn’t exactly zoom up the hill, I still had to ask how the heck he managed to make it over the Rockies. “It takes me about three days to push the bike UP the mountain, but only about two hours to go DOWN it.”

He then went on to tell a story about how he drafted an 18-wheeler down the side of a mountain at speeds that stripped the gears in his mechanical speedometer. When the truck driver finally pulled over, he came back to check his rig. He looked at Phil and said, “Geez, I passed you 50 miles back. What are you doing here?” “I’ve been drafting you. Just how fast WERE we going?”

The truck driver said he had hit 85 mph at one point. [I suspect a large grain of salt might be in order here.]

Phil makes his money sharpening knives. “I love those little towns in the Midwest with about 200 people in them. I’ll stop in the downtown area and sharpen some farmer’s pocketknife so sharp that he don’t know he’s been cut until he sees blood. Before long, half the town is running back into their homes to round up all their knives.”

On the way back south, I ran into Phil, still plugging away northbound at 4 mph.

One hint if you run into Phil on the road: ride upwind.


Phil poses with his bike and homemade trailer.